Saw Installation

1. Ensure the sawblade turns in the same direction as the spindle does. Lf not, accidents are likely to occur.
2. Choose the flange whose inner diameter is the same as that of the sawblade but the outer diameter is a little larger than 1/3 (for multi-rip sawblade is 1/2) of the sawblade. Ensure the flange is clean, not over worn, bent and distorted shape.
3. Check the tolerance between the sawblade and the spindle. Install the flange and fasten the screw.
4. Be sure no people stand in front of the machine when starting the machine. Do not feed, just to check whether there is any vibration, radial or axial run out.
5. Sawblade reprocessing such as bore trimming or reboring, should be finished by the factory. Poor reprocessing would lead to poor quality and may cause injuries.
6. While installation, the sawblade should be 5-6 teeth higher than the board surface.

YAMAOO TECHNICAL DATA


Cutting material applicable cycle speed table


Limit table of rotation number